by PsyberPhlier » Fri Jan 02, 2015 2:24 pm
Its kind of a lazy day around here today, so not doing much.
I did build up the rudder, see pic.
To replicate my work, glue up the perimeter of the rudder as shown on the plan except do not glue C5 to the spar 1. When the glue dries, cut C1 at the leading edge of the spar to create the rudder. Next, glue a similar spar between C1 and C5 as shown, to create a vertical stab.
I filled in the bottom of the rudder with scrap sheet balsa to form a strong point to attach a micro control horn.
NOTE - I used the wider spar material for all internal parts, including the spars. Total weight for both pieces, 1 lowly little gram.
Ted
You do not have the required permissions to view the files attached to this post.
"Chief Dumb Thumb"