500 F6F Hellcat Build Question

Ask other modelers for a little help / knowledge ?

500 F6F Hellcat Build Question

Postby Frank Model Builder » Thu Jul 29, 2021 1:06 am

For you old time/experienced model builders this will be a trivial question but I am just getting back into model building and could use some advice.

I decided for durability I would monokote this build. (I also want to try it because as a kid I did the tissue covering and was always envious of those who could do the monokote covering. It always looked so good.)

Here is the question. If I am covering this with monokote should I assemble it first (insert wing and tail into the fuselage) and then monokote it or monokote the separate assemblies first and then assemble them? I am a bit apprehensive of my ability to insert the wing through the fuselage if it is covered before insertion.

Thanks much for you advice,
Frank
Frank Model Builder
 
Posts: 4
Joined: Tue Jun 29, 2021 4:28 pm

Re: 500 F6F Hellcat Build Question

Postby Johnny ace » Sun Aug 01, 2021 7:54 am

I've done monokote on large r/c and tissue on Guillows.My feeling is to do the parts separately,then assemble,with balsa-to -balsa joints.
Johnny ace
 
Posts: 69
Joined: Thu Feb 26, 2015 9:07 am

Re: 500 F6F Hellcat Build Question

Postby Frank Model Builder » Thu Aug 05, 2021 4:13 am

Thx much for your suggestion.
Frank Model Builder
 
Posts: 4
Joined: Tue Jun 29, 2021 4:28 pm


Return to General Building Questions

Who is online

Users browsing this forum: No registered users and 1 guest