Hello...I am new to this forum.
I have a question regarding laser cut parts...especially as it applies to the Wright Flyer. I have read that sanding the burnt edges of the parts can be a "tedious" undertaking. But I'd like to know from someone who has actually built this model what their experience was.
Thanks to anyone who can share that info.
Eric
Sanding laser cut parts
3 posts
• Page 1 of 1
Sanding laser cut parts
by WFDAWG » Fri Jul 17, 2015 10:57 pm
- WFDAWG
- Posts: 2
- Joined: Wed Jul 15, 2015 9:35 am
- Location: Wilmington, NC
Re: Sanding laser cut parts
by goose » Sat Jul 18, 2015 10:26 pm
Yes it is a tedious affair to sand each and every one of those pieces that are used on the Flyer, But it is well worth it.
If you look close, I didn't get all of the burn marks off of the wood, just most of them.
Mike
If you look close, I didn't get all of the burn marks off of the wood, just most of them.
Mike
You do not have the required permissions to view the files attached to this post.
Creating Sawdust.
- goose
- Posts: 104
- Joined: Mon Sep 19, 2011 10:33 pm
- Location: Littleton, CO, USA
Re: Sanding laser cut parts
by WFDAWG » Sat Jul 18, 2015 11:21 pm
Thanks, Mike. With the pic you attached, you've completely answered my question.
Appreciate it.
Eric
Appreciate it.
Eric
- WFDAWG
- Posts: 2
- Joined: Wed Jul 15, 2015 9:35 am
- Location: Wilmington, NC
3 posts
• Page 1 of 1
Return to General Building Questions
Who is online
Users browsing this forum: No registered users and 4 guests