Guillow's Model Builders Forum

by **Szyp** » Sun Jul 10, 2011 1:49 pm

I messed up the rudder on my 405LC Warhawk, and cannot figure out which sheet I need- the parts are numbers C1,2,3,4,5,6,7. Can anyone help me with what sheets to order- I does not matter if they are die cut or not. Thanks for any help. :?:

by **Szyp** » Sun Jul 10, 2011 2:43 pm

I found the Guillow laser cut replacement part page, but I still don't know what sheets to order. I also emailed Guillow, and if past performance is any indication, I should hear back from them very, very soon. Any advice is still welcome, however. :!:

by **wmikedavis** » Sun Jul 10, 2011 5:17 pm

Copy the part of your plan with the rudder on it...cut the pieces from the copy and glue stick them to a piece of balsa the thickness desired...then cut them out with an Exato knife...this would be far cheaper than the postage on the sheet. :wink:

by **Szyp** » Sun Jul 10, 2011 5:20 pm

Great idea!! Now why couldn't I think of that? :idea:

by **Szyp** » Sun Jul 10, 2011 5:33 pm

I forgot to say thank you. The task is accomplished- again, thank you!!

by **Szyp** » Mon Jul 11, 2011 2:14 pm

By the way, even though you have the most and best tools, you still die. That's the only bad thing- I am very lucky in that I am 64, my Dad died recently at 93 and was a builder, so I have every possible tool know to humans, and I don't even know what some of them are. :!:

Guillow's Model Builders Forum

Help needed

Help needed

I found the laser cut parts replacement page

Who is online