Guillow's Model Builders Forum

by **Deadstick Dave** » Thu Feb 10, 2011 12:05 pm

I recall building with pre-shaped balsa on leading and trailing edges.

I have set of "Baby Ringmaster" plans and would like to build from them ergo my interest in pre-shaped balsa.

If no longer available may the parts be made with a router or Dremel and are bits available to do so?

Thanks, Deadstick

by **Tinkerman74** » Thu Feb 10, 2011 1:00 pm

When I worked at HobbyTown USA they had pre-shaped leading and trailing edges. Don't recall sizes or prices.

Tinkerman

by **Deadstick Dave** » Thu Feb 10, 2011 1:33 pm

Tink:

My LHS is a hobby town; I'll check and see. Thanks!

Deadstick

by **flyright** » Fri Feb 11, 2011 7:32 am

The best there is:

www.lone-star balsa. They had a fire but are now back again.
Great balsa and very good prices.

by **Deadstick Dave** » Fri Feb 11, 2011 9:06 am

flywright:

The link doesn't open because access is required and, if I can't open the link, how can I gain access.

"Catch 22" all over again. :roll:

Deadstick

by **Bargle** » Fri Feb 11, 2011 8:06 pm

Try this link instead.
http://www.lonestar-balsa.com/

Guillow's Model Builders Forum

Pre-shaped balsa still available?

Pre-shaped balsa still available?

pre shaped balsa

Who is online